ASM LOGO

Helping Solve Processing and Materials  Problems using Scanning Probe Microscopy since 1990.

CD stamper bumps, perspective view

 

CONTACT US:
Phone:  1-800-374-8557  Fax: 1-317-895-5652
e-mail: info@asmicro.com

Search this site.

Contents

Home
: Products and services for AFM, STM, and SEM
: Applications of AFM and STM
   : CD
   : DVD
   : HD-DVD
   :Blu-Ray
   : Hard Disks
   : Magnetic Tape
   : More
: Pharmaceutical materials
     : Collagen fibers
     : Collagen monomers
     : DNA Plasmids
   : Polymer molecules
   : Orthopedic implants
   : Opthamalic Devices
   : Diagnostic devices
   : And More
   : Powders
   : Naturally occurring (cellulose)
   : Blends
   : Copolymers
   :Homopolymers
   : Material domains
   : Paper
   : Packaging materials
   : Cast, extruded, or molded polymers
: Coatings
   : Paint
   : Paper finishing
   : Can coatings
: Electronic Materials
   : Silicon
   : Silicon Carbide
   : Germanium
   : Gallium Arsenide
   : Wafers
   : Thin Films
: Automotive
   : Corrosion
   : Wear
: Energy Technologies
   : Corrosion
   : Calalysts
: New materials including ultra high strength magnets
: Optics & Photonics
   : Diffraction Gratings
   : Modified surfaces
   : superpolished optics
   : Ultrasmooth surfaces
   : IR
   : Visible Light
   : UV
   : X-Ray
: Telecommunications

: Metals

:Gallery of interesting images

:Links

 

Z Drift and its repair

Large sample NanoScope AFMs, such as the Dimension 3000, 5000 or Vx series, or the BioScope, sometimes suffer from a problem we call “Z drift”. Upon engage, the Z position of the tip (as measured by the Z center voltage) is supposed to be near the center of the Z piezo range and, ideally, the average Z position should stay nearly constant while scanning, except as needed to track the surface topography. When an AFM suffers from Z drift, the Z position starts near the center of range at the moment the tip engages the surface, but then changes so that the Z position approaches or exceeds the retracted or extended limit. This can be annoying and costly. It is annoying when Z drift is accompanied by XY drift, resulting in distortion of high magnification images. It is more annoying when images of rough surfaces are partly out of range. It is costly when high forces are produced at the retracted limit, damaging the surface or breaking the tip.

Whether Z drift is a critical problem for you depends on how rapid the Z drift is, how long you want to scan at a single engage spot, and on other requirements. ASM has recently developed a service procedure for diagnosing and correcting the problem, achieving a great reduction in the Z drift rate without the need for expensive replacement or overhaul of your Z stage.

If your AFM has Z drift, contact ASM. We can help.

 

Trademark and Copyright Notice

 

Hit Counter